Dvalin 0 Posted April 10, 2019 Greetings everybody! I was planning on buying a new CE6000 Plus and a Hotronix Autoclam soon, but I just ran across a deal on a very slightly used CE6000 and Autoclam for $2200. I'm wondering if the price is good enough to make the older machine worth buying or if I should stick to buying new? Thanks for any advice you may offer. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 10, 2019 offer them $2000 and get the deal - - IMHO once you see both work properly Share this post Link to post Share on other sites
Dvalin 0 Posted April 10, 2019 59 minutes ago, Dakotagrafx said: offer them $2000 and get the deal - - IMHO once you see both work properly Thanks! They were asking $2500, but I may get it down to $2000. The equipment has been boxed up for a couple years, so I doubt a demo is going to happen, but I'm going to ask. Thanks again Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 10, 2019 43 minutes ago, Dvalin said: Thanks! They were asking $2500, but I may get it down to $2000. The equipment has been boxed up for a couple years, so I doubt a demo is going to happen, but I'm going to ask. Thanks again For that kind of price, the equipment would be out of the boxes and running. It doesn't take long to set up a Graphtec, and download the driver for it. You could even have that done on your own laptop and take it with you. The software and driver is available 24-7 on the Graphtec site or most any other software already has Graphtec listed in it. 1 Share this post Link to post Share on other sites