Recommended Posts

4 minutes ago, scottbaggerly said:

ok thanks

Or try a different version of the Graphtec software.  like Cutting Master.  Or try Signblazer   Trials  of Vinyl Master, Signcut,,  Your welcome.

Share this post


Link to post
Share on other sites

where it says JOB SIZE,  why do you have 382.074 %? (hard to read the screen shot)  It should be 100%  All of mine are, and so is Dakota above. 

  • Like 1

Share this post


Link to post
Share on other sites

Okay. So now that we know that the job size is over 3x bigger than it should be (in your cutter settings). Go back to the design window and get your graphic to be the actual size you need it to be.

If your design 'area' is too small, then you need to make it bigger. It's usually a good idea to maybe have it set to the width of the vinyl.

Then try the cut again.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now