BrentD84 0 Posted January 15, 2019 Hi Guys! I am new to the forum, but I've had my MH721 for a little over a year. Recently, it started being extremely slow. No matter the speed I have it set to, it cuts very slowly and sluggish. It seems to be, when it gets to a point it has to lift up, it stops, groans, then goes back to cutting. Doesn't matter what speed I have it one. I've restarted it, checked the fuse, restarted my PC, checked all settings I could think of. Nothing helps. It is still cutting very accurately, which is what has me puzzled. What used to take 30 seconds to cut out, is now taking 3-4 minutes. Any idea? I have attached a small video. This is at 1000mm/s Speed! video-1547593008.mp4 Share this post Link to post Share on other sites
