jandyk

SB designs to PNG file

Recommended Posts

I have been using signblazer for 10 years, I am curious to know if I can do designs and turn the file into png for using to upload to POD? My dimensions needed are 5400x5400 and 300 dpi. If anyone has any info only to properly do this or if it is an option, I would appreciate it greatly!!! Thank you

Share this post


Link to post
Share on other sites

searching online there seem to be free online converters from .eps to .png.  I have never tried them. 

What is POD?

Share this post


Link to post
Share on other sites

That is going to result in a very sizeable file.

You should be able to export it as a .jpg, then just another design software, ie. PS, to take care of the dpi and size you need, then save it as a .png.

Share this post


Link to post
Share on other sites

I don't believe the PNG file existed when SignBlazer was created. You're best bet is going to be saving the file as an EPS.

I'm curious too, what is POD?

Share this post


Link to post
Share on other sites

If no bitpamp output in SB, export as eps and use Inkscape to render it.  It is free.  That dimension and dpi is going to be over 80mb.  Might have to wait a min or three for it to render.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now