storm2313 25 Posted December 26, 2018 I'm trying to cut mirror film, and I have not been able to get my registration marks scanned. I'm using VinylMaster XPT, and can't figure out how to change the ARMS type registration marks. I see you can manually add them if your using a cutter without it, but didn't see an option for ARMS to adjust the marks other than their size in general settings. My Graphtec CE6000 works great on other materials, but this one isn't working. I find if I apply transfer tape over the marks to make them less reflective the laser picks up the edge of the tape rather than getting to the registration mark. Is their a way around this? I really appreciate any advice. Thank you. Quote Share this post Link to post Share on other sites