Setting for tool holder going higher between cuts

Recommended Posts

Ok yall, I am cutting some fairly thick material that i used to do on my titan.  it comes in at 22mil and both machines are cutting it fine.  the problem is that the Graphtec doesn't raise the blade high enough between cuts.  I know I've seen somewhere that the advanced settings has a spot for raising the blade higher after a cut but I can't find it.  hopefully it is available through the plotter controller as I am still without my #1 button.  Thanks in advance

Share this post

Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now