Kenziewalker

Volcano heat press not regulating temp

Recommended Posts

Contact UScutter, they do not answer questions here. This is primarily a user to user forum. It should be under warranty if you purchased it from them. 

Share this post


Link to post
Share on other sites

last year uscutter quit supporting anyone that is not the original purchaser of items - even those that are sold exclusively from them - I would still call and ask for troubleshooting tips  - it could be a thermo resister or the control board and they might (again might) offer some insight into known problems as it is a safety issue with the product.   Being private labeled chinese it might be hard to track down the manufacture and find parts  

Share this post


Link to post
Share on other sites

1. Connect the power cord to the press and a 110 volt outlet. Turn the power switch on. The Display Screen should illuminate. 2. Press SET button. The Display Screen should read P-1. This is where you set the temperature you would like to press with the up and down (Adjustment Setting) arrows then press SET again to save. Keep palet open during the heating process. 3. Once you have the desired temperature input, press the SET button again and the Display Screen should read P-2. This is where you set the time alarm for the press. Press SET again to save. Once you have both time and temperature set up, press the SET button one more time and the Display screen will revert to the current temperature of the press which will eventually settle on whatever you programmed the final temperature to be.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now