Kenziewalker 0 Posted August 2, 2018 My volcano that I just purchased used will not regulate temp. It just keeps doing higher until I turn it off. Is this fixable? Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted August 2, 2018 Contact UScutter, they do not answer questions here. This is primarily a user to user forum. It should be under warranty if you purchased it from them. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 2, 2018 last year uscutter quit supporting anyone that is not the original purchaser of items - even those that are sold exclusively from them - I would still call and ask for troubleshooting tips - it could be a thermo resister or the control board and they might (again might) offer some insight into known problems as it is a safety issue with the product. Being private labeled chinese it might be hard to track down the manufacture and find parts Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 2, 2018 1. Connect the power cord to the press and a 110 volt outlet. Turn the power switch on. The Display Screen should illuminate. 2. Press SET button. The Display Screen should read P-1. This is where you set the temperature you would like to press with the up and down (Adjustment Setting) arrows then press SET again to save. Keep palet open during the heating process. 3. Once you have the desired temperature input, press the SET button again and the Display Screen should read P-2. This is where you set the time alarm for the press. Press SET again to save. Once you have both time and temperature set up, press the SET button one more time and the Display screen will revert to the current temperature of the press which will eventually settle on whatever you programmed the final temperature to be. Share this post Link to post Share on other sites