MrJoel 72 Posted May 25, 2018 Hey y’all, just curious if anyone knows how to tell the cutter to start cutting on one side and progress to the other. I’m basically doing a honeycomb pattern with hexagons over a 12x12” sheet and it cuts the same pattern every time but it’s all over that mat as it cuts... seems very inefficient! Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 26, 2018 That feature is in the cutting software. You need something like optimize cutting order. Flexi software has it. I think I read where Signcut does. But not sure with a pattern like that, your lines might not meet..People use that feature for perfect straight stripes, it helps a lot with tracking problems. Share this post Link to post Share on other sites