Not so sure 0 Posted April 18, 2018 I am trying to replace my cutting strip. I can not get the clear plastic off the new tape, not even sure if it has adhesive on it but my cutter doea not for sure... I have a us cutter MH 721 can someone recommend a tape that does have adhesive for this cutter ir tell me what exactly i neef to order...tia Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 18, 2018 did you order that new one from uscutter? https://www.uscutter.com/Cutting-Strip-for-MH-Series-Cutter-Plotter-Various-Sizes Share this post Link to post Share on other sites
Not so sure 0 Posted April 18, 2018 It does not stick and i do not know what to do Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted April 18, 2018 I would ask support - it has been a long time since I had an MH and they have had 2 redesigns since I had mine - maybe someone that currently has one will happen along I do remember on one cutter using banner tape to hold a cutting strip down but make sure you don't get any wrinkles in the tape etc because the strip has to lay flat Share this post Link to post Share on other sites
Not so sure 0 Posted April 18, 2018 Thank u for the info.. Share this post Link to post Share on other sites
haumana 1,220 Posted April 18, 2018 Hmm.. My LP has "lips" in the track where it holds the cutting strip down. Although it is far easier to do when some of the curled up tension is released from being shipped. Have you tried thin double-stick scotch tape? Share this post Link to post Share on other sites
darcshadow 1,625 Posted April 18, 2018 Probably not ideal I know, but I have some vinyl over the top of my cutting strip to hold it down/patch some cuts. Seems to work well for me. Share this post Link to post Share on other sites