Steel_HEMI 0 Posted March 25, 2018 new to this forum, have never had this issue with my machine. I have seen suggestions for a Z Chip, but that is no longer available. the problem is the carriage will no longer lift, it drags throughout the cut. anyone know of a possible different issue? I have not been able to get USCUTTER support on the phone for assistance. thanks, Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 25, 2018 does it ever lift? if z chip for the first mh series I happen to still have some z-chips but not sure when they changed the mainboards and if the z-chip is different on the new ones. so you are saying the blade holder never goes up and down? Share this post Link to post Share on other sites