mfatty500 454 Posted March 24, 2018 I'm trying to help another person with this model. She says the machine will not act as if it is cutting without the blade installed in the blade holder is this true? Thanks Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 24, 2018 negatory ghostrider - just threw an empty holder in mine and told it to cut a square and it went thru the mo Share this post Link to post Share on other sites
mfatty500 454 Posted March 24, 2018 what about with no holder at all? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 24, 2018 there is no sensor to tell if one is there or not Share this post Link to post Share on other sites
mfatty500 454 Posted March 24, 2018 i didn't think so, hmm, I think there's a short between the wall and the machine Share this post Link to post Share on other sites
mfatty500 454 Posted March 24, 2018 turns out the person I was helping didn't have the vinyl loaded when she tried it 2 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted March 24, 2018 yup there was a short 1 2 Share this post Link to post Share on other sites
arty-rc 719 Posted March 24, 2018 When all else fails, read the instructions Share this post Link to post Share on other sites