Sign in to follow this  
Laone Mokgosi

signblazer cannot respond with my Ct 630h

Recommended Posts

hellow good people i was requested to try using Signblazer because i had problem with corel draw while cutting . Now my i have a problem with Communication of Signblazer to the cutter , the com

and the name of the cutter are both selected at setup in the signblazer . 

This is what happens ,when i write a text then click on the cutter then cut and cut tile the fans start running, on the cutter it displays WORKING but doesnt cut the vinyl,no movement 

 

 

Share this post


Link to post
Share on other sites

If you have the correct driver installed, and the correct COM assigned, then it sounds like your machine is offline.

Share this post


Link to post
Share on other sites

now only the rollers are moving but then its rolling out  the vinyl  and i really haven't understood how the software operates when it comes to cutting the vinyl cause  i'm seeing space in between the cutter and vinyl 

IMG_20180324_100430.jpg

Share this post


Link to post
Share on other sites

make sure when you setup your vinyl to cut, once it's adjusted on the cutter - you need to reset the origin X, Y to 0 (zero), or the cutter will want to go where the 0, 0 point is to start cutting.

 

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this