Beavis97 4 Posted February 27, 2018 Here are some small decals i have just started to try out. I am using an Epson 2000 and 1100 printers(pigment ink) with matte white printable vinyl and oracal transparent laminate. Just started doing some and if anyone has any other helpful tips would be great. Been looking for fluorescent printable vinyl. 1 Share this post Link to post Share on other sites
Sue2 920 Posted February 27, 2018 How're the colors holding up in the weather/sun? Sue2 Share this post Link to post Share on other sites
Beavis97 4 Posted February 27, 2018 6 minutes ago, Sue2 said: How're the colors holding up in the weather/sun? Sue2 So far good. Have had one sitting out in the sun for 3 weeks with some RC nitro fuel that I poured on it to test how it would hold up to that part too Share this post Link to post Share on other sites
Sue2 920 Posted February 27, 2018 I use Jexar coated adhesive stock in my aqueous wide format and with the Epson pigment printer. Then apply Lamex clear laminate over it... The colors hold up very well but I have found the sticker edges start to curl up over time... like maybe the Lamex is shrinking some. Sue2 Share this post Link to post Share on other sites
Beavis97 4 Posted February 27, 2018 Yes I have noticed s bit of shrinking. Was cutting both vinyl and laminate at same time, but may have to find out how to do an overdcut and cut them seperate Share this post Link to post Share on other sites
Sue2 920 Posted February 27, 2018 Mostly I noticed shrinking after time outside in the sun...maybe after a year or so. Sue2 1 Share this post Link to post Share on other sites