da5id

Cutting paper and card stock

Recommended Posts

Hi there, 

I'm using a Titan 3 to cut paper and card stock and I'm having trouble finding a good carrier sheet. I got some adhesive ones of Graphtech and they were so tacky that the paper stuck to them, ruining both the paper and the carrier sheet. I then tried some Saga cutting sheets, and the same thing happened, ruining both. Do y'all have recommendations on a good setup for feeding paper through the cutter? 

Share this post


Link to post
Share on other sites

What about this stuff?  Available at walmart.  (says it is 'repositionable')

d4f6935d7b79e5498af6236d9eb60c4e--dream-

Share this post


Link to post
Share on other sites

Good suggestion. It may work, but I worry that it'll leave tacky residue on the backside of the paper. I should try it though. 

Share this post


Link to post
Share on other sites

Well, some residue will indeed remain, so while you are already at walmart, buy some of THIS --

71n7-iIC3GL._AC_UL160_SR160,160_.jpg

Share this post


Link to post
Share on other sites

Solution so far has been to mount paper onto a large, thin cutting board (purchased from a cooking supplies store) with drafting tape all around the edges. 

Share this post


Link to post
Share on other sites

I have a Cricut cutting matt and experienced similar concerns as you about too sticky. I basically dirtied mine up until it wasn't so bad. A little lint and dust did the trick. 

  • Like 1
  • Haha 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now