Recommended Posts

hi guy hope someone can help before I pull all my hair out

I have a pcut cs630 and I'm using flexi 10 software after installing this on a windows 10 computer every time I send to plotter the carriage shoots to the left until it hits the cut out switch.

I have checked baud rate is 38400 and its running on com 3 

Share this post


Link to post
Share on other sites

Are you absolutely certain the 38400 is the correct baud rate? I have not had my P-Cut for several years but that seems off. 

  • Like 1

Share this post


Link to post
Share on other sites
42 minutes ago, Wildgoose said:

Are you absolutely certain the 38400 is the correct baud rate? I have not had my P-Cut for several years but that seems off. 

Should be 9600, I do believe

  • Like 1

Share this post


Link to post
Share on other sites

hi guys changed it to 9600 in flexi and com settings now it just says on the cutter "working com-connection" when I send but no movement from the head

Share this post


Link to post
Share on other sites
On 10/01/2018 at 6:41 PM, bonkingbilly said:

hi guys changed it to 9600 in flexi and com settings now it just says on the cutter "working com-connection" when I send but no movement from the head

bonkingbilly did you ever get this sorted out? I have the exact same problem with the 'working com-1 Connection'.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now