GHEENEE1 2 Posted November 28, 2017 What is the best way to install a new cut strip, on a Titan 2 28"? The manual says to apply heat. Without adhesive how would this work? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted November 28, 2017 I have read double stick tape, carpet tape or banner hem tape. will work. Share this post Link to post Share on other sites
GHEENEE1 2 Posted November 28, 2017 Thanks. Wonder why there is tape over the existing cut strip. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted November 28, 2017 I just read in another forum that you could turn the strip over and use the back side. until it is bad. Clean the surface first. Titan is a rebranded Saga "The Saga cutting strips are rectangular. You can pull it off, flip it over and use the back side. We use double sided sticky tape to hold it down and we also put a piece of scotch tape over the top of it to secure it in place." Share this post Link to post Share on other sites
GHEENEE1 2 Posted November 28, 2017 Cool didn't even think about turning it over. Share this post Link to post Share on other sites