Recommended Posts

I just got a new SC2 us cutter and when I send the picture to the plotter the plotter carriage slide all the way to the left and hits the wall like if it wants to keep sliding and then returns back to the other side and it do the same and then start cutting. I am getting so aggravated by this because I just got this cutter as a upgrade to replace the sc series that it was damage as well and now this. 

Share this post


Link to post
Share on other sites

Make sure that you put the carriage head to the far right and push the ORIGIN button before you send any vector files to the vinyl cutter. 

Share this post


Link to post
Share on other sites
2 minutes ago, MZ SKEETER said:

Make sure that you put the carriage head to the far right and push the ORIGIN button before you send any vector files to the vinyl cutter. 

I did and still do the same thing I reset it to the origin point and still do the same thing. It goes all the way to the left and hits the wall a few times , comes back to the right and hit tje wall as well and then start to cut

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now