clb

Graphtec ce5000 robo errors

Recommended Posts

I have been using my Graphtec ce5000-40 with cutting master 2 on a pc for a long time. Yesterday I don't know what happened but my cutter keeps erroring out. I tried changing the command from hp-gl to gp-gl and it errors in both modes.  tried resetting the defaults and no luck. what am I doing wrong? when I load the media and press roll 2 it measures the width then shoots the whole roll through the cutter.

Share this post


Link to post
Share on other sites

   What's the error?   Did you try factory reset?  Hold down the UP arrow while turning on the power.   Reinstall everything.

I have never used Cutting Master or Craft Robo with my Graphtec. 

 

Share this post


Link to post
Share on other sites

Sounds like the length sensor is dirty or shot. Try cleaning it with a q-tip.

Or at first try roll 1.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now