ericlecarde 1 Posted September 22, 2017 I've been having this really annoying issue where the right half of the roll cuts fine but the left cuts thin. The thin parts don't weed at all. It looks like the the thin spots occur where the large gap is between the rollers on the left side of the cutter. I tried increasing the force and changing the blade but no luck. Any ideas? Share this post Link to post Share on other sites
MrJoel 72 Posted September 26, 2017 Check the Teflon strip the cutter goes over when cutting. I had a creation cutter a few years ago that the Teflon strip had something under it on one end and cause all kinds of issues. I also had a friend who botched a job and let the vinyl run through while it was still trying to cut...that really messed up his cutter strip on one end but not the other. Remember, you are taking fractions of a millimeter so the slightest burr along that strip can cause havoc Share this post Link to post Share on other sites
ericlecarde 1 Posted September 30, 2017 I think this solved most of my issue. Thanks a lot! Now I need to replace the strip since there are scrapes in it. Share this post Link to post Share on other sites
