KT4406 0 Posted August 14, 2017 My LP cutter has been cutting things I've designed 1/4-1/16'' of an inch smaller than I have designed in Flexi. It may not seem like a big deal, but considering I'm cutting license numbers for airplanes, which have very strict rules, it becomes a big deal quickly. HELP PLEASE!| I have checked the weed line, and there are no boxes checked. I also checked the knife offset, which is set to .030inches. I'm not sure what the blade offset does exactly. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted August 14, 2017 Go to the resolution in Flexi and calibrate... Cut a box, say 3" long. Measure it, adjust the steps in resolution so that it is 3" long. May take a few tries. 1 Share this post Link to post Share on other sites