MrJoel 72 Posted August 12, 2017 I stepped away while it was cutting and the feed was off a bit, second row the blade holder hit the side of the vinyl and now the belt is moving but the cutting head is not ... how does it attach? Any instructions anywhere? Share this post Link to post Share on other sites
MrJoel 72 Posted August 12, 2017 Figured it out...kinda just sits in a tab by lifting up and sliding down while pulling back towards the cartridge... Share this post Link to post Share on other sites
MrJoel 72 Posted August 12, 2017 The edge of the vinyl was too far from the pinch roller apparently (almost 1.5") Share this post Link to post Share on other sites