Suicide449 0 Posted July 17, 2017 Hi everyone I'm Steve from pittsburgh and new to vinyl cutting just wait I g for my cutter to get here if anyone has any advice feel free to help and if I can help anyone in anyway I will Share this post Link to post Share on other sites
Jburns 239 Posted July 17, 2017 welcome from Denver! Share this post Link to post Share on other sites
cardudenc 151 Posted July 17, 2017 welcome aboard, I'm a yr old newbie from myrtle beach, since we started our biz I have met several peeps from your area. you joined a great forum, this is a board full of knowledge and helpful people. I wished I had found this place b4 I ordered my cutter. would've prob done a few things different Share this post Link to post Share on other sites
Wildgoose 4,200 Posted July 17, 2017 Welcome from Idaho. There are many facets to owning and operating a cutter. One biggie is the graphics. What program did you get with your cutter? I would spend as much time as you can practicing on the vector design work. If you have access to at least a trial version of what you purchased that would be a good place to start. If not or in addition to your cutting software you might try out Inkscape which is a free open source vector program that many people use as their design platform. Share this post Link to post Share on other sites
arty-rc 719 Posted July 17, 2017 Welcome from SE Florida. Share this post Link to post Share on other sites
Cal 393 Posted July 17, 2017 Welcome aboard. What cutter are you waiting for? Cal Share this post Link to post Share on other sites
dwp99 283 Posted July 18, 2017 Hello Steve and welcome to the forum. Share this post Link to post Share on other sites