dtdm 1 Posted May 19, 2017 Out of nowhere my graphtec fc8600 started cutting 3/16ths an inch off... I can't figure this one out. It seems like it's trying to use tool holder 3 instead of 1, its set up to use 1 and tool holder is in 1. ( I wish it were human error) In cutting master 3 there is no distance adjustments. In cut file, the cut lines are set up properly. The only work around I have found is to shift all cut lines down 3/16ths of an inch. Does anyone have any idea what exactly this could be? I have gone through the manual, double checked all settings, created a totally new cutting condition... but nothing is correcting this issue. Please help! Share this post Link to post Share on other sites
