Macee80 5 Posted February 20, 2017 Hi all, a friend of my recently was unloading his setup, that he had not used in awhile. I wanted to buy just the material, software, clipart and stuff, but I had to “take the whole works”. So now here I am with another cutter, but no drivers ect.. I see that I will need an adaptor from parallel to usb to run with my newer pc. What I am trying to find out, can I use this with windows 10? Id like to put this to work on smaller stuff rather than the roland. If not, im not entirely sure what im going to do with it. Thanks. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 20, 2017 using my good friend google I found out that a roland pnc1000 driver works fine with that plotter. so far I have not had any problems with any of my equipment working with windows 10 Share this post Link to post Share on other sites
Macee80 5 Posted February 20, 2017 35 minutes ago, Dakotagrafx said: using my good friend google I found out that a roland pnc1000 driver works fine with that plotter. so far I have not had any problems with any of my equipment working with windows 10 I will give this a shot thanks Share this post Link to post Share on other sites