Pebbles1488 6 Posted February 11, 2017 I am having an issue with my cutter/setup. When it cuts, let's say a letter, it does not complete the cut from beginning to end point. I have to use a razor knife to finish it. Is there a way to fix this? Is there a setting I need to change? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 11, 2017 scalp, flexi and vinylmaster all have overcut to fix this with the stepper motor cutters - don't remember on signblazer if it had it Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 11, 2017 As I suspected no overcut in signblazer, the owner died 8 years ago so development stopped then Share this post Link to post Share on other sites
Pebbles1488 6 Posted February 11, 2017 Is there a program that is similar that you can suggest? I've been using this SO long, I wouldn't even know how to transfer all my files over or anything! Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 11, 2017 Vinyl master pro. Flexi starter if you want to design in one and cut in another 1 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 11, 2017 Export your designs as eps and they will import into most software, that is why I save all mine in eps 1 Share this post Link to post Share on other sites
bigmax 166 Posted February 12, 2017 Not sure but I think your blade offset is what needs to be adjusted. 2 Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted February 12, 2017 the offset doesn't look right either but knowing what offset is and what overcut does is the difference. not connecting is an overcut need . . . 2 Share this post Link to post Share on other sites
