Sign in to follow this  
signman911

Can someone tell me what is going on

Recommended Posts

Creation ct630 one picture is what i see before i cut and the other is when cutting

and it cuts the lines across the letters

post-1354-12986518855888_thumb.jpg

post-1354-12986518875596_thumb.jpg

Share this post


Link to post
Share on other sites

In the first picture, the dashed lines is just where the blade is moving to. Only the blue or red solid line is where it will actually cut.

Now if you are saying that the blade is cutter on the dashed lines as well, then maybe you pressure settings are too high. Try lower the pressure to maybe 80 to 100 and try the cut again.

Hope that helps

Share this post


Link to post
Share on other sites

Thanks i cut 4 of them  i only use 80 pressure it doesn't cut all the lines that i see but

some of them enough to ruin a couple letters from each one

Share this post


Link to post
Share on other sites

try adjusting the blade to where less sticks out. The only other thing I can think of is that the blade isn't lifting as it should,which could be due to static electricity.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this