Sign in to follow this  
bh0307

titan 3 28" cuts good on one side not the other

Recommended Posts

Got a brand new titan 3  when I am cutting to images side by side the one on the left get little tear hole in it like you shot it with a shot gun , the right side cuts fine. Anyone seen this ??

20161018_184536.jpg

20161018_184544.jpg

Share this post


Link to post
Share on other sites

call support - the one side looks like it is pulling the vinyl up like too much blade exposure but if that was it it should be doing it on both sides too

 

Share this post


Link to post
Share on other sites

Look at your cutting strip were the blade runs.  If there are cut marks in it, like maybe you cut too deep or cut off the vinyl at some point, it will do this  If this is the problem, take a piece of clear packing tape and put it over the cut marks.  I had this same problem.

Share this post


Link to post
Share on other sites

Double check you file for stray nodes too. I can't tell from the pics but it looks like there are a bunch of cuts outside the image that would be garbage left from an auto-trace

Share this post


Link to post
Share on other sites

Thanks For all the help . I put in new blade adjusted it.  slow down my speed and not as much forge, Everything seem to be working fine now, Guess just been Newbie  lol.   

Here is one after the adj. still learning alot.

20161023_151200.jpg

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this