VinylMaster 148 Posted October 10, 2016 (edited) USCutter Edition Updates: This webpage has the very latest builds of all USCutter versions:http://fcws1.com/usc1.htm Non-USCutter Edition Updates: This is the updates please go to this webpage:http://iifuture.com/vmfull/getvm.htm Edited February 10, 2017 by VinylMaster Updated link... Quote Share this post Link to post Share on other sites
David800 0 Posted April 30, 2017 i don find my psn location!!! Quote Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 30, 2017 Are you saying you don't have your number? Where did you buy it? Quote Share this post Link to post Share on other sites
cardudenc 151 Posted May 6, 2017 look for the card that has the product key on it or the email from when you bought it Quote Share this post Link to post Share on other sites
cardudenc 151 Posted October 15, 2017 so whats up with the site? I tried to dn load 1 trial versions of any of 1 other versions of vm other than cut. said it was emailing me a link , never got 1 1 Quote Share this post Link to post Share on other sites
VinylMaster 148 Posted October 27, 2017 It is emailed and may have gone into your Junk or Spam folder. Quote Share this post Link to post Share on other sites
cardudenc 151 Posted December 11, 2017 I don't guess there is anyway to go back to the version of VM I had before the update?? If I'm not mistaken I lost a few things I used. Quote Share this post Link to post Share on other sites
Beavis97 4 Posted February 22, 2018 So when you upgrade from cut to ltr. I downloaded new, but it still loads up as cut and don't see any of the new features Quote Share this post Link to post Share on other sites
julian keller 20 Posted April 12, 2018 13 hours ago, Artech said: please help Best bet is to go here and either call or file a support ticket: https://www.uscutter.com/index/page/static/subpage/contact_us I am having issues with saving so that is what I did. They are quick to respond. Quote Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted April 12, 2018 No, best bet is to contact SAI. That is Flexi software the OP is having problems with. UScutter does not do support for Flexi software... And they do not sell Creation Pcut cutters anymore.... Without the op telling us how they are getting this error, (what are you doing to get this error.?) Pretty hard for the forum to answer. esupport@thinksai.com 1 Quote Share this post Link to post Share on other sites
Guest Richard Posted December 7, 2021 Is there any way to download older versions to VM Cut (US Cutter edition)? 4.3 seems to have lots of small issues on the SC2. Most of the calibration items don't work. Vinyl cuts fine, contour cutting looses steps and gets WAY out of alignment, even with no pressure on the pen. Quote Share this post Link to post Share on other sites