SewDarnHot 0 Posted October 8, 2016 Hi, I have been out of commission for quite some time. My copam was josstled quite a bit when moved and now will not show the screen for more than a brief second. The screen will light up when turned on but will only light for a second and then it goes out. I tried all the connections, blew it, cleaned with electronic cleaner, I have checked all the soldering connections and do not see any breaks. Lots I have read lead back to the mother board. Is there anyone that I can send by motherboard to and they can check and see if that is the issue before I go buying a new one? Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted October 9, 2016 thats going to be a tough one - last year uscutter blew out all the copam mainboards on ebay after they quit selling them a while back - so they don't even have any anymore - never seen anywhere you can send one in here is one from overseas http://www.sign-in-china.com/products/18550/motherboard_with_serial_or_usb_port_for_all_copam_vinyl_cutters_cp2500_3500_3050_4050_4500_original.html Share this post Link to post Share on other sites
SewDarnHot 0 Posted October 18, 2016 Thank you. I thought there was a member here that offered at one time to have it sent to them and they would plug it in to see if it was the board. I don't know if its the board or the screen. I'll need to plug it in again to remind myself but I think the light would come on for the screen then go away before I could change settings and such. I believe the settings got changed and it will send to cut and try but the settings are all off so its not working right. Share this post Link to post Share on other sites