long644 0 Posted September 22, 2016 Hi I'm new to this vinyl hobby . I have a 14" desktop MH Us Cutter . I'm using VM 4.0. I start off uploading the image then vectorizing it . After that I want to do a contour cut set that up and do contour wizard before cutting. Cuts fine til the end of cutting it always have a vertical Cut straight through my image. I used a pen plotter to demonstrate what's happening. Please help. Thanks Share this post Link to post Share on other sites
Wildgoose 4,200 Posted September 22, 2016 wow even doing it on the test cut. Is the test cut done through VM4? Can you do a test without the program on that cutter? Some will do it if you press a certain key combination. Share this post Link to post Share on other sites
andygeekboy 62 Posted September 23, 2016 Have you registered VM? i believe some of the software will put a line thru when sent to cut if not registered, but I'm still new to this so ymmv Share this post Link to post Share on other sites