Cher2086 1 Posted August 12, 2016 Hi have a pcut and when its cutting it seems to missing tiny bits of the letters or numbers that i am cutting i have changed blade and doesnt help any suggestions Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted August 12, 2016 Add to the over it in your cutting software. The stepper motor cutters have this problem more as the blade is stopping a slight bit before the end , usually due to the coarser " steps" the motor sets to measure distance. Also many ti,Es we find it worse when people have too much blade exposure because the read to use a credit card to measure the exposure. Take the holder out and drag it across the vinyl and adjust until it just cuts thru the vinyl and barely leaves a mark on the backing. Then reinsert the holder and adjust your force Share this post Link to post Share on other sites