Leway

Graphtec flash nv error

Recommended Posts

I was working with my graphtec ce5000-60 and had to reload my media, when i off and on the plotter i got a flash nv error. Can one help guide me on what to do?  Thanks in advance for your kind response.

Share this post


Link to post
Share on other sites

Did you try to do a factory reset?

 

Turn machine power off

Hold UP button while turning power back on

Share this post


Link to post
Share on other sites
16 hours ago, Dakotagrafx said:

not good - do they have a graphtec in nigeria you can contact?

They are not competent and when u say not good how bad is it. I need urgent help.

 

Share this post


Link to post
Share on other sites
16 hours ago, Dakotagrafx said:

not good - do they have a graphtec in nigeria you can contact?

 

35 minutes ago, Leway said:

They are not competent and when u say not good how bad is it. I need urgent help.

 

Well, from what I have heard, if you are unable to get your machine going again after doing the "factory reset" it most likely means you need to replace the main board.

But, you could try downloading and reinstalling the firmware...

http://www.graphtecamerica.com/graphtec-america-support-downloads-cutting-plotters-discontinued-legacy-cutting-plotters-ce5000-60-120

 

  • Like 1

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now