v1sualFX 0 Posted July 24, 2016 I am the newest of the greenhorns in the cutter world, i purchased a used Tc model cutter from a gentleman whos uncle passed away. Unfortunately he cannot find any software or any drivers that might have come with it or any that his uncle may have purchased. My question is, where to start? I have flexiSIGN10 however i the TC model doesnt come up when trying to install my Uscutter. am i just stuck with a cutter that wont work because of the lack drivers? Im searching for downloads and any guidance would be greatly appreciated. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted July 24, 2016 http://support.uscutter.com/support/solutions/folders/14000106692 Share this post Link to post Share on other sites
skarekrow 1,842 Posted July 24, 2016 1 hour ago, v1sualFX said: My question is, where to start? I have flexiSIGN10 however i the TC model doesnt come up when trying to install my Uscutter. am i just stuck with a cutter that wont work because of the lack drivers? Not only is the TC a great cutter, it is well supported with software. In SignCut (a free Trial download) the later model is listed as "Liyu TC" and the other older model, I believe, is listed under "US Cutter TC". SignBlazer (abandon ware) supports it as well a trial download of VinylMaster. If I recall correctly, there is also some RS-232 emulation driver software that may be necessary to install. 1 Share this post Link to post Share on other sites
slice&dice 2,450 Posted July 24, 2016 Don't get frustrated. You could be up and running with THIS ----> http://download.uscutter.com/SBEforUSCutterSetup.exe also hosted on a private server HERE ---> http://www.thebuttontaylor.com/sb/SBEforUSCutterSetup.exe 1 Share this post Link to post Share on other sites