kentukblue 0 Posted May 1, 2008 Just got a Creation PCut Ctn630 and ive got to the point where i loaded signblazer. I have the serial to USB driver installed and have the COM port # matched up. Ive made some manual cuts in "Offline" mode. But its now online and i cant get it to cut the test image with signblazer. I go to cutter...cut....then cut tile. The box shows the text and the letters are being outlined in blue like the plotter should be cutting...no dice. What should i do? Share this post Link to post Share on other sites
BannerJohn 1,324 Posted May 1, 2008 Is your baud rate set correctly? Is the flow control set to 'hardware'? Share this post Link to post Share on other sites