socceronly 0 Posted May 27, 2016 When I turn on my plotter, it says 60 V6.00GL So I tried to update the firmware to 6.4 I get either BAD FIRMWARE or CHECKSUM ERROR Any idea how to get around this? I just get it syncing endlessly with Win 10, AI 2015 CM and Studio Has never worked since upgrading to Windows 10. Thanks JM Share this post Link to post Share on other sites
mb20music 760 Posted May 27, 2016 Factory reset maybe? Turn off cutter, hold down up button while turning back on for factory reset. Share this post Link to post Share on other sites
socceronly 0 Posted May 27, 2016 Factory reset maybe? Turn off cutter, hold down up button while turning back on for factory reset. I have read that a few places. Tried it. All I get is NOVRAM then HL metric ENG GL metric KANA HL inch ENG No other options in the menu, and nothing about a factory reset. Of that is the FR into those base options..... no effect if that is the case. Maybe it's possessed. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 27, 2016 Turn on the cutter while holding down the UP arrow>. Click the button beside HL inch ENG, then click ENTER Or roll you computer back to previous windows where it was working. . 1 Share this post Link to post Share on other sites
darcshadow 1,626 Posted May 27, 2016 The bad firmware/checksum error is a plotter thing, nothing to do with windows. Have you tried downloading the firmware update again? Those error messages would indicate that the file you are trying to load is corrupted, or being corrupted during the load process. Share this post Link to post Share on other sites