Laura 0 Posted May 18, 2016 I am trying to learn how to do a print and cut but my registration marks are to far off the mat and cannot figure out how to move them so they will print on my paper. I have a silhouette cameo and scal4. Help please! Been at it for hours and haven't accomplished anything. Share this post Link to post Share on other sites
MZ SKEETER 4,709 Posted May 18, 2016 You might have more luck seeking your answer at Craftedge.com Scalp has it's own forum. Share this post Link to post Share on other sites
busterbay 326 Posted May 18, 2016 You cant move them - make your mat bigger or the item smaller. The reg marks are used by the program to find it's location for the contour cut. As of your situation, you have have something very small on your mat that you are not aware of causing the issue. Share this post Link to post Share on other sites
