tadbowman 0 Posted May 3, 2016 Can someone help me setup this cutter to work with a Mac? Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 3, 2016 Plenty of info on the Roland site. Are you sure it is Mac compatible? http://support.rolanddga.com/_layouts/rolanddga/productdetail.aspx?pm=cx-24 Share this post Link to post Share on other sites
tadbowman 0 Posted May 3, 2016 I'm not sure. It's older. Only has serial ports. Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 3, 2016 if your cutter doesn't have a serial port the get a keyspan brand adapter and make sure to use the cable that came with that cutter - as I recall they had special ends on them Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted May 3, 2016 I'm not sure. It's older. Only has serial ports. I only see windows drivers on their website for it. Share this post Link to post Share on other sites
tadbowman 0 Posted May 4, 2016 It does have a serial port. I was hoping to find a way to use a Windows driver on my Mac. Share this post Link to post Share on other sites