Sign in to follow this  
lesliel

How do i send Coreldraw to my laserpoint 2

Recommended Posts

Hello,

 I just purchased the Corerldraw x8 and i'm having problems sending it to the cutter. any advise is appreciated.

Share this post


Link to post
Share on other sites

Corel draw is not cutting software.  It is design software,  You must use a cutting software to send to your vinyl cutter.. If your cutter was purchased from UScutter then install the cutting software that came with it,, and drivers for your vinyl cutter.  Send Corel draw vector to your cutting software, then cutting software to your cutter. 

 

Here is the set up instructions.

 

http://www.uscuttersupport.com/laserpointII-vinylcutter-setup.html 

Share this post


Link to post
Share on other sites

then you would export your artwork out of corel into a file format that you could import into scalp so you can cut it -

Share this post


Link to post
Share on other sites

Bet you were hoping you could do the Corel Draw to the cutting software right? I never did it heck I didnt even know you could do that with SCALP. I will stick with Cutting studio.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this