sherndon1122 1 Posted April 6, 2016 Just setup my new laser point II plotter today, went to make my first cut after setup and noticed that when the cutter moves from one letter to the next it cuts off part of the previous letter? It seems to not be going up all the way when it moves to the next position or something? I have the blade depth set correct? Any suggestions would be appreciated! Share this post Link to post Share on other sites
JohnatUSCutter 49 Posted April 12, 2016 I'm going to guess that you haven't registered your program. The software thinks you are in "demo mode." That's just a guess. If that's not the issue, let me know. Share this post Link to post Share on other sites
MZ SKEETER 4,708 Posted April 12, 2016 I'm going to guess that you haven't registered your program. The software thinks you are in "demo mode." That's just a guess. If that's not the issue, let me know. John, that was a duplicate post, already answered... http://forum.uscutter.com/index.php?/topic/51479-cutting-across-letters/ Share this post Link to post Share on other sites