stealey1986 1 Posted March 24, 2016 hi i have a graphtec fc3100-120. its been disconnected for a few months but was working in November. i have connected it back up to the computer it was running with sign blazer but when i send a job to cut it doesn't go to the cutter and the output on sign blazer says its idle?? any ideas please cheers Share this post Link to post Share on other sites
KYSIGN 233 Posted March 25, 2016 I don't own your cutter or use your software but did you connect it back into the same USB port as before? Share this post Link to post Share on other sites