jet1012 1 Posted March 7, 2016 HI I am hoping someone can help. I have been going through a ton of posts, can't seem to find one with the same issue. I have LP II and using Signblazer, I have had a lot of issues and thought I had finally was good with everything. I am finding that no matter what size the image is the end of the image the cutter will "lightly" miss a small spot of the image, for example a 12x30 quote and it just grazed the about .5" of the design. I can see the line, but it is not fully cut for weeding. I am assuming this a setting issue, but I am not sure where to start. Any ideas? (This is only happening at the end of the image) no matter which way I am cutting. Thanks Share this post Link to post Share on other sites