kimmy123 0 Posted January 23, 2016 Hey guys my cutter has just developed a fault all of a sudden. I have been cutting out vinyl this morning all fine then all of a sudden its started misaligning the weed frame. I am currently cutting sheets of sunstrips with a weed frame around the entire sheet. The weed frame is mis-aligning all of a sudden by about 3-5mm and is cutting off the bottom of one of the sunstrips each time (only by a couple of mm) All the design is cut out fine with nothing out of line its just the final weed frame, i've also noticed that weed lines i have put across the design to help with picking out are finishing a couple of mm before the end (once again no issue with this with the actual design its all the weeding lines) I'm not sure if it all comes down to the final external weed box been out of line causing the other lines not to join up. I haven't tried anything yet as i aren't too technically minded so don't want to start changing settings etc. I cut out using Signcut pro Any help would be appreciated Thanks Kimmy Share this post Link to post Share on other sites