tomk 19 Posted November 13, 2015 Hi All, Anyone have experience perf cutting with Flexi and Graphtec cutters? I've got a 7x10 layout, with stickers and stuff that is printed and contour cut within the sheet just fine, what I'd like to do is have it go back and do a perf cut around the sheet so I don't have to hand cut each of these (talking 100's of 7x10 sheets). Thanks! Share this post Link to post Share on other sites
hhsg 43 Posted November 27, 2015 tomk Do you have a perf cut color in flexi? I use flexi and roland versaworks. To use the perfcut in flexi I had to create a spot color and put it in my color profile. Share this post Link to post Share on other sites
PointOfExpression 53 Posted November 27, 2015 I have always done all my perf cutting in cutting master 2 on my graphtec. I have flexi as well but couldn't figure it out. Share this post Link to post Share on other sites
tomk 19 Posted November 27, 2015 Thanks Guys, I was hoping I didn't have to stop and move the blade to the other holder and then recut, which is a pita. Easier to run them through a paper trimmer when they come off the plotter. Share this post Link to post Share on other sites