speedyts 3 Posted November 4, 2015 My LaserPoint stops cutting during a cut session. Sending artwork through with SCAL3 pro. SCAL says all info is sent to cutter, shortly after it stops cutting. Share this post Link to post Share on other sites
xpaperman 719 Posted November 6, 2015 using USB by chance? Share this post Link to post Share on other sites
speedyts 3 Posted November 6, 2015 Yes. Figured out that the connection is bad so it must be getting interupted when sending the data. I've purchased a serial to usb cable but can't get the cutter to communicate with SCAL. It shows up in the list of COM ports. US Cutter tech support is useless. Share this post Link to post Share on other sites
jaybyrd 3,770 Posted November 12, 2015 Have you tried what is suggested in every post of this type? TrippLite keyspan adapter and null modem serial cable ? Doubt very much serial to usb is going to work Share this post Link to post Share on other sites