n2paint 0 Posted October 29, 2015 My name is Chris, I own a USCutter LP2 that I have had for about a couple years now. I currently use SCAL3P but am looking to upgrade. When I purchased the machine I was doing all kinds of designs and misc decals for friends and family, then the machine was put away for almost a year since my grand daughter was born and we needed the room. I have been dying to start with it again. Got it set back up now and for the past month ive just been doing random cuts getting used to weeding and designing again. Im currently out of work, but im hoping I can use my setup to generate some income while im out of work for now. Ive been reading posts most of the day today and learning quite a bit. I didnt even know about this forum until yesterday LOL. Share this post Link to post Share on other sites
Cal 393 Posted October 29, 2015 Welcome aboard, you will get a lot of useful & helpful info here! Cal Share this post Link to post Share on other sites
Wildgoose 4,200 Posted October 29, 2015 Welcome from Nampa! Share this post Link to post Share on other sites
dwp99 283 Posted October 29, 2015 Hello and Welcome. Share this post Link to post Share on other sites
knucklehead 530 Posted October 29, 2015 Hello, from the Deer Capital of Georgia Share this post Link to post Share on other sites
Sal316 166 Posted October 30, 2015 Welcome from CT. Share this post Link to post Share on other sites
hhsg 43 Posted November 28, 2015 Welcome from Indiana Share this post Link to post Share on other sites
Dawn's Design 403 Posted November 28, 2015 Welcome aboard. . Share this post Link to post Share on other sites
xpaperman 719 Posted November 28, 2015 Howdy from Texas.... do you have a heat press too? Shirts almost sell themselves! Share this post Link to post Share on other sites
