bigmark1972 0 Posted October 21, 2015 Hey guys have a CE-6000 cutting magnetic sheet and it's working great. Issue is my patterns have radius corners the cutter should easily be able to cut without lifting up the blade in these radius corners. It's cutting fine but it's lifting in the corners and it's annoying. I can't seem to find a setting in cutting master 3 to make it simply go around the radius in one smooth motion without raising the blade. Can anyone point me in the right direction? Thanks Share this post Link to post Share on other sites
Trillion 0 Posted December 11, 2015 Turn off tangential mode Share this post Link to post Share on other sites
bigmark1972 0 Posted December 11, 2015 Thanks for the reply but it is already off . Share this post Link to post Share on other sites
Jeremy76 0 Posted April 14, 2018 I just got my Graphtec for a week, got the same issue and solve it. What i do is adjusting the blade to make it point out further, and lowering the force, keep the force under 9, lowering the Acceleration speed to 1. Hope this will solve your problem. Share this post Link to post Share on other sites