damonclark73 0 Posted July 31, 2015 I replaced the blade holder/carriage in my LaserPoint 2 cutter. Turn it on, sent a job to the cutter and it cut with no problem. I press reset for whatever reason on cutter and it will not stop trying to move, almost like it is stuck. I have unplugged, replugged and when I power it back up same then, constantly running. Does anyone have any ideas? I have about four jobs due tomorrow....any help would be appreciated. Also installed updated software yesterday. Share this post Link to post Share on other sites
slice&dice 2,450 Posted July 31, 2015 There is a 'kill switch' located within the upper housing, and it might not be properly coming into contact with the carriage as it moves across. I had an SC cutter that had this problem, and I simply bent the contact arm slightly, resulting in the switch closing correctly. Share this post Link to post Share on other sites
jaybyrd 3,770 Posted August 5, 2015 FORE !!!! He found a hazard and had to stop playing. Share this post Link to post Share on other sites