Sign in to follow this  
xJoey Dubsx

Origin after vinyl is cut...

Recommended Posts

So I picked up a desktop to use rather than my old slow laptop. I got Signblazer on it, and cutter is working fine, but after job it sets the cutter back at the original origin, rather then advancing past the job to next available uncut vinyl. How do I go about fixing this? MH721 with Signblazer 6.0 on Windows 8

Share this post


Link to post
Share on other sites

can't remember exactly on signblazer but most software has an advance after plot check point you can check to it advances

Share this post


Link to post
Share on other sites

Here you go - screenshot. Advance after job should take care of it:- mine is set to zero- I think it went back to origin

Signblazer%20Setting.jpg.png

  • Like 1

Share this post


Link to post
Share on other sites

I have mine set to 2.50. It advances the vinyl just the right amount to run a blade along the cutoff slot in the Graphtec.

Share this post


Link to post
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
Sign in to follow this