tooler82 182 Posted May 27, 2015 I put this sticker on an Army ambulance. This happens all the time when I put a sticker on somewhere with a crease. Any ideas on how to make this lay down? Share this post Link to post Share on other sites
jaybyrd 3,770 Posted May 27, 2015 Looks like air bubbles. Poke them with an exacto or single edge razor smooth out with your finger and for added insurance you can go over it with a heat gun Share this post Link to post Share on other sites
Dakotagrafx 7,297 Posted May 27, 2015 if lifting after the fact I have to ask if you are using a cast and post heating after installation? Share this post Link to post Share on other sites
tooler82 182 Posted May 27, 2015 I use 3M IJ35-C-10 for the signs I make, and I post heat. Share this post Link to post Share on other sites
Wildgoose 4,200 Posted May 27, 2015 I use 3M IJ35-C-10 for the signs I make, and I post heat. That's calendared vinyl from what I see on the website. That is probably a lot of your issues. Cast will deal with this much better. Share this post Link to post Share on other sites
towman208 38 Posted May 27, 2015 looks like someone needs to learn how to do body work and make the hinge line not be there. Share this post Link to post Share on other sites
tooler82 182 Posted May 27, 2015 All Army ambulances are like that with the hinge. You can open or close them to make the vehicle an ambulance or not. Share this post Link to post Share on other sites